SPARTAN ARMOR/CONDOR MOPC PLATE CARRIER AND SPARTAN™ OMEGA™ AR500 BODY ARMOR PLATFORM

Fits Spartan Armor Systems™ 10″x12″ Spartan™ Omega™ AR500 Body Armor/AR550/Armaply Shooter’s Cut armor plates, SAS IIIA Soft Armor, and our Level IV composites

– Emergency drag handle.
– Detachable shoulder pads.
– Side release buckles on shoulders and internal waist strap.
– Accepts up to 6 x 8 side panel plates.
– Easy access to ballistic plates with pull down flaps.
– Adjustable/detachable cummerbund with pockets for side armor.
– One front map pocket with snap, hook & loop closure.
– All armor compartments (front, back & sides) have hook and loop panel.
– Lightly padded mesh on front and back harness for comfort and airflow.

Constructed from lab certified Spartan™ Omega™ AR500 Body Armor, (1/4” thickness) these plates provide the operator with Level III protection IAW NIJ0101.06 standards.

With all of our Spartan™ Omega™ AR500 Body Armor products, we only use ballistic LAB CERTIFIED AR500 steel! All purchases of our Spartan Armor products have current lab certificates available on request. Remember, not all body armor is created equal! Read our "FAQ" to find out more about the steel we use to construct out body armor!

You have the choice of getting our Spartan™ Omega™ AR500 Body Armor formed on a continual radius die. Or with our Advanced Triple Curve ™.  Instead of bending our formed plates in 2 different locations as we used to, we have machined custom tooling to give these plates a nice curvature to best conform to the side of your torso. Spartan Armor Systems™ is proud to be the FIRST in the industry to commercially offer triple-curved Spartan™ Omega™ AR500 Body Armor. Spartan Armor Systems’ ATC™ body armor allows the operator to shoulder their weapon with the most freedom and limited discomfort. The ATC™ armor better “hugs” the operator’s body, resulting in a significant increase in comfort. Our CNC equipment capabilities have allowed us to create dies which form our body armor without any “crease” bends. Crease bends, “work hardens” the plate and causes a significant amount of stress to the portion of the plate under load. We HIGHLY suggest when doing research to ask if they crease bend their body armor. This process results in increased potential for plate fatigue and failure, which is why Spartan Armor Systems™ has gone the extra mile to create this die process.

 Full Coat or Base Coat Options: 

We are excited to announce our potentially “life saving” breakthrough!  The strike face for our plates is mark embedded with our Spartan logo! Both sides of these plates are coated, however, the back side only has a “courtesy coat” to protect against wear and rust. The front of the plate is lined with 1/4-3/8 of our proprietary coating, Encapsaloc ™.  The result is a plate approximately 1/2-5/8” total thickness.  See our FAQ for more information about our Encapsaloc ™ process. Due to popular demand, we have added a “base coat” only option for our AR500 armor products. The base coat option has an extremely thin layer of our fragmentation mitigation coating to aesthetically enhance the plates, and to provide corrosion resistance. This coating has minimal, if any, fragmentation mitigation capabilities.